Stainless steel nipples
Hexagonal
Fattening nipple
It has a plastic lid with a water flow regulation system
to adequate it to the installation’s pressure, and with a
removable filter that guarantees no impurity found in
water will make the nipple drip.
Thread
Male 1/2”.
How we manufacture them:
MUR system,
Without springs.
– Water saving.
– Minimal maintenance.
– Long durability.
Thread
Male 1/2”.
Saves water: Water comes out through the center of
the pin, avoiding spills.
Easy maintenance: No springs. The pin is activated
with a rubber block that acts as a spring, avoiding the
continuous. maintenance required for spring-activated
nipples.
MUR-10 nipple.
Nipple manufactured entirely in stainless steel. No springs.
Activated with a rubber block inside it. Plastic lid with
removable filter. Water out let through inside the pin,
avoiding spills.
Sprayer drinker
Sprayer drinker, with an outlet that spreads
the water over the whole trough.
Thread
Male 1/2”.
This type of drinker is used in wet feed hoppers or in feeders where
the water has to be spread out.
It has a plastic lid with a removable filter which guarantees no impurity
found in water will make the drinker drip.
Hexagonal
Piglet nipple
Thread
Male 1/2″.
Manufactured in just one piece and smaller, special for piglets.
It has a plastic lid with a water flow regulation system to adequate it to the
installation’s pressure, with a removable filter which guarantees no impurity
found in water will make the nipple drip.
Stainless steel 45º elbow
For a fast installation of nipples.
With the stainless steel 45º elbow we achieve a fast installation
of the nipples. Due to its unique design, it attaches to the wall
with two screws, and it has two female 1/2” threads on each
side, one for attachment of the water inlet and the other one
for the nipple.
As it is manufactured robustly and in stainless steel, a long
durability is guaranteed.